How a LifetimRadon Radon Mitigation System Works

radon reduction system  LifetimRadon

There are two basic types of radon mitigation systems: Level 1 and Level 2. Level 1 systems use a pipe that extends through the wall or roof and terminates outdoors. Both systems use pipes that need to be properly sealed to ensure the lowest radon concentrations possible. Level 2 systems use a pipe that runs through the walls and ceilings and terminates outside. Both types use plumbers’ strapping, which is usually installed every seven or eight feet in horizontal or vertical runs. Installation is not recommended in garages, closets, or other areas where pipes might be exposed to dust or debris. Find Out – radon reduction system | LifetimRadon

A good radon reduction system will include diagnostic testing and a warning device. The warning device will notify the homeowner if there are any problems with the system. It will also provide a guarantee of at least four pCi/L radon levels. This is a very important feature.

While sealing foundation cracks is an important part of many radon reduction systems, it is not the best method. Studies have shown that sealing alone is not effective enough and can increase radon levels. Moreover, it’s difficult to completely seal radon entry points. Additionally, the settling of a home opens new, old routes for radon.

The installation of a radon reduction system will depend on the type of your house. There are three basic types: basement, slab-on-grade, and crawlspace. Some houses use more than one of these foundation designs, which will require a combination of radon mitigation techniques.

Leave a Reply

Your email address will not be published. Required fields are marked *